Multi-shaft bevel gearboxes V

Angular bevel gear unit V multi-shaft, in cast iron housing. Small ratios i = 1:1, 1.5:1, 2:1, 3:1, 4:1, 5:1, 6:1. Maximum output torque 5400 Nm. Maximum input speed 3000 [1/min]. Standard rotational backlash < 30 arcmin, reduced < 6 arcmin. 9 groups of gear sizes from 65 to 350 mm. Optional housing and shafts made of stainless steel 1.4305.

Multi-shaft bevel gearboxes V

Properties of multi-shaft V-bevel gear units

• Precise and efficient torque converters.
• High-performance gear units meet the high requirements of our time in every respect.
• Compact and impact-resistant.
• Used worldwide in all branches of the mechanical and plant engineering industry.
• Reducers are also called bevel gear units, angle gear units, multi-shaft gear units, gear wheels or step-down and step-up gear units.
• Wheel sets with high-quality spiral teeth made of hardened case-hardened steel.
• The wheel set consists of a bevel pinion (low number of teeth / small diameter) and a bevel gear (high number of teeth / large diameter).
• The advantage of gear units with spiral teeth is the very favorable meshing conditions (high degree of meshing).
• Quiet, insensitive to shocks and vibrations, highly elastic with maximum power density.
• Robust, strong, compact
• Grey cast iron or steel housing
• Maintenance-free – no oil change required under standard operating conditions
• 9 gear sizes from 065 to 350 mm edge length
• Standard backlash < 30 arc minutes
• Reduced backlash S2 < 10 arc minutes
• Reduced backlash S1 < 6 arc minutes
• Reduced backlash S0 < 4 arc minutes
• High efficiency 94 – 97%
• IP54 protection class
• NBR seal as standard
• Ambient temperature from -10 to +90 degrees C
• Various types of lubrication depending on the application
• Maximum input speed 3000 rpm
• Various output shaft shapes: solid shaft with key, hollow shaft with keyway, smooth hollow shaft with clamping ring, spline
• Available with VL adapter – connection flange adapted to various types of engines

Optional versions of V multi-shaft bevel gear units

• special paints and oils for the food industry
• VS version increasing the rotational speed with ratios of 1:1.5 and 1:2
• in stainless steel housing – HDV version
• with VC servo motor adapter: square adapter flange and clamping clutch for mounting servo motors in the IEC standard.
• with VL synchronous motor adapter with round flange
• splash-proof and dust-proof version
• IP56 protection class
• FKM VITON seal
• ATEX explosion-proof version